User's Manual

Battery change
Use 1.5V AAA battery 2 EA
1. Slide clip upward to open the battery cover.
2. Replace the battery. Pay attention to the polarity.
3. Slide the cover back into the position until it clicks.
4. Check if the laser pointer functions properly.
Setting up the i-POINTER
1. Install the battery on the Remote Controller.
2. Insert the Receiver into the USB Port
3. The i-POINTER is installed automatically and will work after it is inserted into the USB
Port.
4. LED light on the Receiver starts blinking. Press any UP or Down button on the
Remote Controller for two seconds until LED light becomes steady OFF.. The blink
works when push the buttons.
5. Open MS PowerPoint. Check the operation by pressing [c] and [d] buttons on the
Remote Controller. PowerPoint frame should move forward or backward after pressing
the button.