Installation Guide

Made in the USA

U.S. Patent No. 10,513,835 and U.S. Patent No. 10,316,486

Professional-Grade Roll Out Flooring

Installation Guide

Step 1: Remove the product packaging and unroll your Garage Grip® to set in

place.

Step 2: Unfold the panel at center and lay in place (for folded SKUs only).

Note: Photos shown above depict common creases that occur due to folding of 10’x22’, 10’x17’, and 10’x10’ sizes. Crease

appearance may vary. Creases gradually relax over time and when exposed to warm sunlight. Creases may or may not fully

relax over time. Folding of these sizes is required to comply with UPS and FedEx ground shipping restrictions. To avoid creases,

we recommend purchasing multiple 5’x10’ rolls or 7’6”x10’ rolls, which are rolled and not folded.

If you ordered a 5’x10’ or 7’6”x10’, that’s it. You’re done!

If you ordered in SKU’s 10’x17’, 10’x10’, or 10’x22’, each panel arrives folded in half, and will need to be

unfolded prior to setting in place.

PAGE 1
Professional-Grade Roll Out Flooring Installation Guide Step 1: Remove the product packaging and unroll your Garage Grip® to set in place. If you ordered a 5’x10’ or 7’6”x10’, that’s it. You’re done! If you ordered in SKU’s 10’x17’, 10’x10’, or 10’x22’, each panel arrives folded in half, and will need to be unfolded prior to setting in place. Step 2: Unfold the panel at center and lay in place (for folded SKUs only).
PAGE 2
Professional-Grade Roll Out Flooring Step 3 (OPTIONAL): Connect multiple panels by first identifying the overlap edge on your panel. Apply strong double-sided seam tape over this overlap edge and remove the top side seam tape backing. We recommend 3”-4” wide double sided EPDM tape. * * Fully overlap the next mat over the overlap edge with the double-sided tape. Make sure the mats are lined up carpet to carpet for a seamless transition between panels. Press down firmly with your hands to secure.