Instructions / Assembly

5
Assembly
STEP 1:
Attach post with burner
assembly onto heater
housing, using 4pcs
3/16" Stainless bolts
and M5X8 bolt / M5 nut
/washer, keep the access
panel open.
STEP 2:
Attach ring weight to
base, using 4pcs
M6X20 bolts.
STEP 4:
Insert ends of wire
guard into holes in
the post with burner
assembly flange and
put 3pcs washers into
the top of support bolt.
STEP 3:
Put 3pcs reflector spacers into the hole in
emitter use 3pcs nuts to firm the reflector
spacers inside of the emitter.Attach emitter
assembly to post using 4pcs bolts and
washers.
STEP 5:
Attach reflector to emitter
assembly,using 3pcs nuts.
STEP 6:
Rotate regulator toward
opening in housing.
Line up threads on gas
cylinder with those on
the regulator.
Insert and rotate cylinder
clockwise until tight.
STEP 7:
Close access panel.