Instructions / Assembly

6
Load Head Assembly by inserting hose into post.
Insert Head Assembly into post.
Control knob should be above decal on post.
Attach Head Assembly to post, and loosely install four
small bolts.
Tighten bolts securely.
Step 6 – Install Reflector
WARNING
Remove protective cover before assemble.
Note: If necessary for proper alignment of reflector
sections, loose each screw prior to further assembly and
retighten after sections are aligned.
.Slide two Reflector
Panels together.
.Insert one Small
Screw.
.Slide one Small Flat Washer over threaded end of
screw and screw on Cap Nut loosely.
.Slide Reflector Plate
onto Reflector Panels.
.Insert one Small
Screw.
.Slide one Small Flat
Washer over threaded
end of screw and
screw on Cap Nut
loosely.
.Repeat procedure to complete the assembly of all four
sections.
.Fully tighten all of the screws in the rolled edge.
9 Req’d Small Screw s
9 Req’d Cap Nuts
9 Req’d Small Flat Washers