Installation Guide

9
ASSEMBLY INSTRUCTIONS
Hardware Used
HH
II
JJ
8
9
8. WARNING:Remove protective cover before
assembling.
Note: If necessary for proper alignment of reflector
sections, loosen each bolt prior to further assembly
and retighten after sections are aligned.
9. Attach reflector panels (A) together using
M6 x 10 mm screws (II) and Φ6 washers (HH).
Secure loosely with cap nuts (JJ).
10. Attach reflector plate (B) to reflector panels (A)
using M6 x 10 mm screws (II) and Φ6 washers (HH).
Secure lo
osely with cap nuts (JJ). Once properly
aligned, tighten all screws and the preassembled bolts.
x 3
x 3
x 3
Φ6 Washer
M6 X 10 mm Screw
B
JJ
HH
II
A
Cap Nut
Hardware Used
HH
II
JJ
x 6
x 6
x 6
Φ6 Washer
M6 X 10 mm Screw
Cap Nut
10
JJ
HH
II
Lowes.com
R