User manual

The pump remains in constant operation because the float switch

is bypassed.

1. Push the float switch

onto the float switch lock

with the

cable downward.

2. Stand the pump on a firm surface

– or –

use a rope attached through the bore hole in the carrying

handle

to immerse the pump in a well or shaft.

3. Plug the power cable

into a mains socket.

The residual water height is only reached during manual

operation since the float switch turns off the pump during

automatic operation before this water level is reached.

Flat suction: Normal operation:

v Turn the 3 swivel feet

180° to 1mm. 180° to 5 mm.

The residual water level of approx. 1 mm is only reached during

flat suction in the manual operation mode. If the water level is

lower than 25 mm, you can accelerate flat suction by switching

the pump off and on 2 to 3 times.

If the water height is lower than 3.5 cm, fill the pump before

operation over the universal fitting

with water.

5. Putting into Storage

v Store the pump away from frost before the first frost sets in.

The product must not be added to normal household waste. It

must be disposed of in line with local environmental regulations.

v Important: Make sure that the unit is disposed of via your

municipal recycling collection centre.

Manual operation:

1 2

Only for the

submersible pump 7000:

Flat suction /

Normal operation

Frost-free storage:

Disposal:

(in accordance with

RL2002/96/EC)

1780-20.960.14_22.08.2011_GARDENA.qxp 22.08.2011 09:36 Seite 15