Operation Manual

English - 31
INSTALLATION
3.7 Checking the installation
Check the loop signal by inspecting the indicator lamp on
the charging station.
• Solid green light = good signals.
• Flashing green light = the loop system is turned off
and the robotic lawnmower is in ECO mode. See 6.8
Settings on page 56.
• Flashing blue light = interruption in the boundary loop,
no signal.
• Flashing red light = interruption in the charging
station’s antenna plate. The fault should be rectied
by an authorized service technician.
• Solid blue light = weak signal. This may depend on
the boundary loop being too long or that the wire is
damaged. If the robotic lawnmower still works, this is
not a problem.
• Solid red light = fault in the circuit board in the
charging station. The fault should be rectied by an
authorized service technician.
See 9.3 Indicator lamp in the charging station on page 73 if
the lamp does not indicate a solid or ashing green light.
3018-216
1157808,Gardena_R100Li-R130Li,GB_151217.indd 31 2016-01-12 09:16:30