Operation Manual
English - 48
MENU FUNCTIONS
Advanced
New loop signal
The loop signal is randomly selected to create a unique
link between the robotic lawnmower in question and the
charging station. In rare cases, there may be a need
to generate a new signal, for instance if two adjacent
installations have a very similar signal.
1. Place the robotic lawnmower in the charging
station to which the robotic lawnmower is to
be connected.
2. Select New loop signal in the menu and press OK.
Press OK and await conrmation that the loop signal has
been generated. This normally takes about 10 seconds.
Change PIN code
Enter the new PIN code and press OK. Conrm by
entering the same code again and pressing OK. When
the PIN code is changed, the message PIN code changed
appears in the display momentarily.
Make a note of the new PIN code on the designated line
in Memo on page 2.
6.5 SensorControl
Only applicable for GARDENA R130Li, R130LiC and
R160Li.
This function allows the robotic lawnmower to
automatically adjust its mowing times based on how quick
the lawn grows. When the weather is good for grass
growth, the robotic lawnmower mows more often and
when grass growth is slower the robotic lawnmower will
automatically spend less time on the lawn.
The robotic lawnmower will however not operate longer
than the time that may be congured in the timer
settings. For optimal SensorControl performance, it
is recommended when setting the timer to only de-
select the times when the robotic lawnmower must not
operate. Other times should be made available for the
SensorControl.
When the SensorControl is activated, the robotic
lawnmower needs time to decide what the optimal
mowing time is for the working area in question. For this
reason it can take a number of days before the mowing
results are optimal.
When the SensorControl is activated, it is very important
to regularly check that the blade disc is clean and that the
blades are in good condition. Any grass twisted around
the blade disc shaft or blunt blades can affect how the
SensorControl functions.
SensorControl
Cutting timeOn/Off
Low Medium High
1157808,Gardena_R100Li-R130Li,GB_151217.indd 48 2016-01-12 09:16:52