Operation Manual
English - 52
MENU FUNCTIONS
Area X > How far?
Enter the distance in metres along the current wire from
the charging station to the remote area where the robotic
lawnmower begins mowing.
Use the number keys to specify the distance in metres.
Tip! Use the Test function to determine how far it is to
the remote area. The distance, stated in metres, will be
shown in the lawnmower display when STOP has been
pressed. See Area X > More > Test on page 51. The
measured distance shown in the display can be saved
directly to the selected remote area. Any current value will
be overridden by the new measured distance.
Area X > How often?
How often the robotic lawnmower must be steered to
the remote area is selected as a proportion of the total
number of times it leaves the charging station. At all
other times, the robotic lawnmower starts to mow at the
charging station.
Select the percentage that corresponds to the size of
the remote area relative to the total working area. If the
remote area is for instance half of the total working area,
50% must be selected. A lower gure must be specied
if the remote area is smaller. If more areas are used, take
into account that the total gure cannot exceed 100%.
Compare with the examples in see 7 Garden examples on
page 58.
Use the number keys to specify share as a percentage.
Area X > Disable/Enable
Each area can be disabled and enabled without having to
reenter the settings. Select Disable/Enable and press OK.
? m
3023-018
3023-019
3023-017
1157808,Gardena_R100Li-R130Li,GB_151217.indd 52 2016-01-12 09:16:55