Operation Manual
English - 67
MAINTENANCE
To replace the blades:
1. Set the main switch to position 0.
2. Wear protective gloves.
3. Turn the robotic lawnmower upside down.
4. Remove the three screws. Use a straight slot or
cross-tip screwdriver.
5. Remove the blade and the screw.
6. Screw on the new blade and the new screw.
Check that the blades can pivot freely.
8.7 Software update
Owners of GARDENA robotic lawnmowers can download
regular software updates from the GARDENA website
and install them on their robotic lawnmowers. Registered
users will be notied of this by email. To download new
software, the robotic lawnmower is connected to a
computer using the accompanying USB cable.
1. Connect the USB cable between your computer
and the robotic lawnmower.
• Remove the service outlet plug on the bottom of
the mower. The service outlet is located beside
the main switch.
• Connect the USB cable to the computer’s USB
ports.
• Connect the USB cable to the robotic lawnmower
service outlet. The USB cable can only be
connected in one way.
2. Set the main switch to position 1.
3. Follow the software update instructions from your
received email.
4. When the mower programming is completed
disconnect the USB cable and t the service outlet
plug. If the seal on the service outlet plug is visibly
damaged, the entire plug must be replaced. Make
sure the plug is locked completely.
3018-231
3012-272
3018-213
3018-256
1157808,Gardena_R100Li-R130Li,GB_151217.indd 67 2016-01-12 09:17:08