Operation Manual

English - 76

TROUBLESHOOTING

b) Put AL and G1 back in their original positions.

Then switch AR and G1.

If the indicator lamp is lit with a solid green light,

then the break is somewhere on the boundary

wire between AR and the point where the guide

wire is connected to the boundary wire (thick

black line in the illustration).

4. a) Assume that the indicator lamp is lit with a

solid green light in test 3a) above. Reset all

connections to their original positions. Then

disconnect AR. Connect a new loop wire to AR.

Connect the other end of this new loop wire

somewhere at the centre of the installation.

If the indicator lamp is green, then the break is

somewhere in the wire between the disconnected

end to the point where the new wire is connected

(thick black line in the illustration).

Guide

3018-232

3018-233

1157808,Gardena_R100Li-R130Li,GB_151217.indd 76 2016-01-12 09:17:13