Owner manual

ManualsBrandsGardman ManualsFor HomePolycarbonate Glazing

Polycarbonate Glazing

Instructions

Polycarbonate Glazing

Instructions

J1-4

J1-9 J1-2

J1-2

J1-3

J1-8

J1-1J1-1

J1-1 J1-1 J1-1

J1-7

J1-9 J1-8

J1-1

J1-5

J1-2

J1-5

Important.

Please read the instructions

completely before starting

assembly.

J1-6

J1-5

8x6

6x6

4x6

8x6

6x6

4x6

Side 2

(without vent)

Side 1

(with vent)

Front

(with door)

Back

Summary of content (4 pages)

PAGE 1
Polycarbonate Glazing Instructions Important. Please read the instructions completely before starting assembly.
PAGE 2
Parts List Greenhouse Sizes Profile 4x6 6x6 8x6 Description Size (mm) Code 9 11 13 617 x 1215 J1-1 2 3 3 1 1 1 Side & End Long Sheets Large Door & Small Roof Sheets Door small (middle) 617 x 608 617 x 226 J1-2 J1-3 1 1 1 Front end apex 617 x 233/16 J1-4 4 5 7 Roof Long sheets 617 x 1140 J1-5 0 1 1 Vent Sheet 605 x 545 J1-6 1 1 1 Back end apex 617 x 670/448 J1-7 2 2 2 Front & Back right corners 617 x 440/20 J1-8 2 2 2 Front & Back left corners 617 x 440/
PAGE 3
Section 1 Before you start: • This task is accomplished more easily with two people. • Gloves and goggles are recommended. No tools required. • Identify all Polycarbonate panels and PVC profiles. • Locate and identify the stainless steel glazing clips from the greenhouse pack. • Locate ‘W’ glazing clips from the greenhouse pack. • It is important to install the panels with the UV treated side facing outwards. This is covered with white polythene.
PAGE 4
Glazing: side panels. • Use stainless steel clips J4-2 and PVC profiles J3 and proceed as indicated in the general glazing instructions. • Once in place, secure with ‘W’ glazing clips G4 as shown, four ‘W’ clips to each side. • Repeat for the other side panels. Glazing: Lower end panels, back and front: • The bottom edge of these panels is glazed in the same as the side panels, using stainless steel clips J4-2 and PVC profiles J3.