Full Product Manual

10
6.0 OTHER FEATURES
6.1 Removing the Angle Indicator Dial
The Angle Indicator Dial on the front of the bender can be removed to use the center of the shoe as a storage area for the 12-R adapter or Pendant and Switch
Control when they are not in use. To remove the front dial, push up on the “OPEN” tab on the face of the bender and pull off the dial. To put the dial back on,
slide the dial up on to the center hole until the latches on the backside of the dial catch the rim of the hole. The dial may need to be slightly flexed outward to
bend it over the rim. Push the “OPEN” tab back down to ensure that the dial is tightly secured to the bender. See Figure 17 and Figure 18
6.2 Removing the Legs
The 3 legs on the backside of the bender can be unscrewed to attach custom-length legs. Simply unscrew the legs and use any 3/4" NPT pipe to replace them.
This can be done in situations where a third-party threader is being used that requires longer legs to bend in the horizontal position, to make a taller base for
the bender, or to replace the legs if they become damaged. See Figure 19 and Figure 20
6.3 Removing the Base and Feet
The bender can be removed from its base. Use a 4mm metric Allen wrench to release the 4 screws holding the bender to its base.
The bender can be moved and attached to any portion of the base. The feet can also be removed by using a 4mm metric
Allen wrench if they become damaged and need to be replaced. See Figure 21 and Figure 22
Figure 17. Push the OPEN Tab to Remove Dial
Figure 19. Unscrew the Legs on the Bender
Figure 21. Remove Screws to Adjust Position
or Remove from Base
Figure 18. Use the Center Compartment as Storage
Figure 20. Use Any 3/4" NPT Pipe
Figure 22. Remove Screws to Remove Feet