Full Product Manual

6.4 Bolting the Bender to a Fixture
6.5 Post Adapter
6.6 Horizontal Threader Mounting Hardware
There are 4 holes on the feet of the bender that can be
used to bolt the bender onto a fixture or table to keep it in place while bending.
See Figure 23
The Post Adapter may be required when using threaders that have a larger clamp rod slot.
Thread the Post Adapter to the Post on the back of the bender.
This is used to give the threader more stability during bending. See Figure 24
To mount the PT200 Power Driver using mounting hardware slide the shaft collar onto the
post on the back of the bender, followed by the 3/4" washer. Next, slide the PT200 onto
the back of the bender until its retaining ring engages with the first notch on the 11-R die
adapter. Slide the 5/16" washer onto the back post and screw the bolt into the end of
the post. Tighten the bolt by hand. Once it is tight slide the shaft collar and 3/4" washer
towards the threader and tighten the shaft collar to lock the threader in place. Finish
tightening the bolt using a wrench to make sure the threader is tightly secured to the
bender post. See Figure 25 and Figure 26
NOTE: There may be some slight variations in the instructions and mounting hardware
required based on the threader being used.
To use the bender in the horizontal orientation with custom extended length legs the threader will need to be secured to the bender or a platform will need to
be added to these extended legs. To secure the threader to the bender use the Horizontal Threader Mounting Kit or install the the items below onto the bender.
These parts can be found at most local hardware stores.
(1) 5/16-18 x 5/8" UNC 2A Flanged Hex Head Bolt
(1) 5/16" x 2" x 0.050" Fender Washer
(1) 3/4" x 2" x 0.150" Fender Washer
(1) 20mm Shaft Collar (Set screw type)
11
Figure 23. Use Mounting Holes to
Attach Bender to Fixture
Figure 24. Post Adapter Placement
on Bender
Figure 25. Horizontal Threader
Mounting Hardware
Figure 26. PT200 mounted onto the
B1000 using mounting hardware