SDS

other involved materials. Move containers from fire area if you can
do so without risk. In the event of fire and/or explosion do not
breathe fumes.
General fire hazards
Extremely flammable aerosol. Contents under pressure.
Pressurized container may explode when exposed to heat or flame.
Section 6 - Accidental Release Measures
Personal precautions, protective equipment and emergency procedures
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Keep out of low
areas. Many gases are heavier than air and will spread along ground and collect in low or confined areas
(sewers, basements, tanks). Wear appropriate protective equipment and clothing during clean-up. Do not
breathe mist or vapor. Emergency personnel need self-contained breathing equipment. Do not touch
damaged containers or spilled material unless wearing appropriate protective clothing. Ventilate closed
spaces before entering them. Local authorities should be advised if significant spillages cannot be
contained. For personal protection, see section 8 of the SDS.
Methods And Materials For
Containment And Cleaning Up
Refer to attached safety data sheets and/or instructions for use.
Eliminate all ignition sources (no smoking, flares, sparks, or flames
in immediate area). Keep combustibles (wood, paper, oil, etc.) away
from spilled material. Stop leak if you can do so without risk. Move
the cylinder to a safe and open area if the leak is irreparable. Isolate
area until gas has dispersed. Cover with plastic sheet to prevent
spreading. Absorb in vermiculite, dry sand or earth and place into
containers. Prevent product from entering drains. Following
product recovery, flush area with water.
Environmental Precautions
Avoid release to the environment. Prevent further leakage or
spillage if safe to do so. Avoid discharge into drains, water courses
or onto the ground. Inform appropriate managerial or supervisory
personnel of all environmental releases.
Small Spill
Wipe up with absorbent material (e.g. cloth, fleece). Clean surface
thoroughly to remove residual contamination. For waste disposal,
see section 13 of the SDS.
Section 7 - Handling and Storage
Conditions for safe storage, including any incompatibilities
Precautions For
Safe Handling
Obtain special instructions before use. Do not handle until all safety precautions
have been read and understood. Pressurized container: Do not pierce or burn, even
after use. Do not use if spray button is missing or defective. Do not spray on a naked
flame or any other incandescent material. Do not smoke while using or until
sprayed surface is thoroughly dry. Do not cut, weld, solder, drill, grind, or expose
containers to heat, flame, sparks, or other sources of ignition. All equipment used
when handling the product must be grounded. Do not re-use empty containers. Do
not breathe mist or vapor. Avoid contact with eyes, skin, and clothing. Avoid