Specification

www.gardner-gibson.com
Gardner-Gibson • P.O. Box 5449 • Tampa, Florida 33675-5449
Phone: [phone]
C-14
AVAILABLE SIZES
PRODUCT CODE UNIT SIZE UNIT DIMENSIONS FILL LEVEL UNIT WEIGHT PACK UPC
0101-GA 1 gal. 6.75” x 6.75” x 7.75” 3.6 qt. / 3.4 L 8 lbs. 6/case 025056010100
0105-GA 5 gal. 12” x 12” x 14.75” 4.75 gal / 18 L 40 lbs. 1 ea. 025056010506
Gardner
®
Fibered Roof Coating is a liquid applied, brushable, asphalt based coating designed to protect worn roof surfac-
es. When applied across the entire roof surface, it provides weatherproong protection from the elements. Also great choice for
damp-proong foundation walls below grade.
PREPARATION: Surfaces must be clean, free of surface rust and loose material.
APPLICATION: Use roof brush and wear gloves, to spread across surface of roof. Apply on a clear warm day with no rain expected
for 24 hours. Apply when surface temperatures are between 50°F and 120°F. This product is formulated to be used year round. In
colder weather (50°F and below), product should be stored in heated room 70°F to 80°F, at least 24 hours prior to application to
promote ease of application. MIXING MAY BE REQUIRED TO ENSURE PRODUCT UNIFORMITY. DO NOT APPLY DIRECT HEAT/
FLAMES OR THIN. Allow product to cure a minimum of 30 - 60 days prior to application of a reective coating.
COVERAGE RATE: Covers approximately 50 sq. ft. per gallon.
PRECAUTIONS: For exterior use only. Protective clothing and eyewear should be used during application of this product. Use with
adequate ventilation. Don’t apply to wet surfaces. Do not use on EPDM, TPO, PVC or other rubber/synthetic surfaces. If there is
a question on compatibility, test a small section rst. When transporting this product, ensure that lid is tight and pail secure and
upright. Do not allow pail to tumble as this may cause lid to loosen and leakage to occur. Do not transport on passenger seats or
inside the passenger compartment of any vehicle. Store product in the cargo area of vehicle, and secure over protective cloths to
prevent damage due to accidental spills. Do not store at temperatures above 100°F. This manufacturer also disclaims liability for at
surface application where poor drainage or ponding water may prevail. Do not reuse empty containers. Do not use in drinking water
or food systems. Seal container when not in use. Protect from freezing.
CLEAN-UP: Clean tools or spills with paint thinner or mineral spirits.
Fibered Roof & Foundation Coating
Liquid Asphalt Coating
010
• Great For Coating Worn Roofs
• Damp-Proofs Foundation Walls
• Fiber Reinforced
• Liquid Brush Grade