Specification

DESCRIPTION: Silver Dollar Aluminum Roof Coating is an asbestos free, reflective
a
nd protective, fibered coating with aluminum flakes suspended in a tough and flexible
v
ehicle of selected asphalt and solvent. Upon application, the aluminum flakes leaf to
the surface to form a reflective metal shield that insulates against the sun's destructive
r
ays, reducing interior temperatures to provide a savings on energy costs.
PREPARATION: All surfaces should be dry, clean, smooth, and in good repair. Surface
t
emperatures should be a minimum of 50°F and rising, not to exceed 110°F. Repair all
leaks and problem areas with White Roof Patch and Glass Fabric. (See back labels of
r
einforcement fabrics for specific repair instructions). Priming is recommended on worn
r
oof surfaces. Specific instructions should be followed according to manufacturers rec-
ommendations. When applying this product to a previously coated asphalt surface, it is
suggested that the surface weather a minimum of one full summer to prevent bleed-
t
hrough and alligatoring.
F
OR BEST RESULTS: DO NOT THIN. STIR CONTENTS WELL BEFORE AND DUR-
I
NG USE AS REQUIRED. Aluminum pigment and fibers settle out, and thorough stirring
is necessary to re-disperse these components prior to use. A power drill mixer can be
very helpful to mix product. In cold weather, store product in heated room (65°F to 80°F)
at least 24 hours prior to coating.
A
PPLICATION: Mix coating and apply evenly by brush or roller to the roof. Spread in
both horizontal and vertical directions, overlapping ends of strokes. Avoid excessive
build-up or puddling. W
hen br
ushing, avoid scraping into existing roof surface. All finish
strokes should be made in the same direction.
D
O NO
T APPLY
IF RAIN IS EXPECTED
WITHIN 24-36 HOURS.
C
OVERAGE RATES: Built-up (roll roofing) 2 gal. per 100 sq. ft.; Smooth surface and
Metal Roofing - 1 1/2 gal. per 100 sq. ft. Avoid foot traffic once applied.
.
NO
TE:
This product is not recommended f
or use on w
ood, asphalt shingles or roofs with
slopes less than 1% (or 1/8" per ft.). Standing water dulls aluminum, and may cause
adhesion f
ailure between the coating and substrate
. In w
armer weather, application to
steep slopes may result in some running of the coating until fully dr
y. Avoid foot traffic
for longest life. When buying multiple containers, it is recommended to match the batch
codes on the lids to avoid shade variances.
CLEAN-UP: Clean tools with Mineral Spirits
REGULA
TORY/ENVIR
ONMENT
AL CHARA
CTERISTICS:
Volatile Organic Compound 500 g/l max. (4.2lbs./gal)
HMIS Rating H-2, F2, R-3, PP-X
RCRA Hazardous Substances
yes
, D001
SARA Title III listing: RQ value 100 lbs
Sec.
302 Extremely Hazardous Substances no
CERCLA Hazardous Substances
no
Sec. 313 Toxic Chemicals no
COMPLIANCE:
Calif
or
nia products meet Los Angeles County A.P
.C
.D
. RULE 66 (Rule
#102).
Gardner-Gibson, Inc. • P.O. Box 5449 • Tampa, Florida 33675-5449
Phone: [phone] • Fax [phone] • www.gardnerasphalt.com
C-05
SILVER DOLLAR FIBERED ALUMINUM ROOF COATING
Data Sheet
See MSDS f
or more inf
o
ASPHALT C.A.S.# 8052-42-4
MINERAL SPIRITS C.A.S.# 8052-41-3
CELLULOSE FIBER C.A.S.#65996-61-4
CALCIUM CARBONATE C.A.S.# 1317-65-3
ALUMINUM FLAKE C.A.S.# 7429-90-5
W
ARRANTY AND DISCLAIMER:
For limited warranty and disclaimer information, contact the Gardner-Gibson, Inc. corporate
office at 1-800-237-1155 or www.gardner-gibson.com.
621
Approx. Shipping Weights: (Note: All approx. weights include container.)
1 gallon (3.8L) 10 lbs
(6) 1 gallon container/case 60 lbs
5 gallons (18.9 L) 50 lbs.
55 drum (208.2L) 540 lbs
Weight Per Gallon, lbs. 9.3-9.5
Residue by Evaporation, % 65 Min.
Combustible Solvents Mineral Spirits
Consistency Brush
Cure Time 4-8 hrs. to set, 24-48 hrs. to
(at recommended coverages) full cure depending on weather
Application Temperatures 50°F - 120°F
Flammability (Flash point, °F solvent) 105°F
Clean up Tools Mineral Spirits
TYPICAL PHYSICAL & PERFORMANCE CHARACTERISTICS
CAUTION: HARMFUL OR FATAL IF SWALLOWED.
EYE, SKIN, AND RESPIRATORY IRRITANT.
USE WITH ADEQUATE VENTILATION.
KEEP OUT OF THE REACH OF CHILDREN
PRECAUTIONS:Protective clothing and eye wear should be worn while using this
product. Keep away from heat and flame. When transporting this product, ensure that
lid is tight and pail secured and upright. Do not allow pail to tumble as this may cause
lid to loosen and leakage to occur. Do not store at temperatures above 100°F. The
manufacturer also disclaims liability for flat surface application where poor drainage or
ponding or moisture may prevail .The container should be tightly sealed to prevent sol-
vent evaporation and to keep out moisture. WATER MAY REACT WITH ALUMINUM
PIGMENT TO PRODUCE HYDROGEN GAS, AN EXPLOSION HAZARD. Do not
reuse empty container.
In Case Of: EYE CONTACT: Flush with water seek medical attention immediately.
SKIN CONTACT: Wash thoroughly with soap and water.
INGESTED: DO NOT INDUCE VOMITING, seek medical attention immediately.
CALIF. PROP. 65 • CHEMICAL WARNING (CALIFORNIA HEALTH AND SAFETY
CODE #25249.5 ET SEQ). WARNING: This product contains chemicals known to the
State of California to cause cancer, birth defects or reproductive harm. Use proper
protection and adequate ventilation, when using product.