Instructions / Assembly

www.gardner-gibson.com
Gardner-Gibson • P.O. Box 5449 • Tampa, Florida 33675-5449
Phone: [phone]
ROOFING
C-15
AVAILABLE SIZES
PRODUCT CODE UNIT SIZE UNIT DIMENSIONS FILL LEVEL UNIT WEIGHT PACK UPC
SK-7801 1 gal. 6.75” x 6.75” x 7.75” 3.6 qt. / 3.4 L 12 lbs. 4/crtn. 025056780164
SK-7805 5 gal. 12” x 12” x 14.75” 4.75 gal. / 18 L 60 lbs. 1 ea. 025056780560
PREPARATION: Pressure washing entire surface is recommended for best results (use only a wide fan spray tip). All surfaces must be dry and free of
dust, dirt, oil, loose granules, gravel or peeling paint and all other foreign matter. Roofs must have proper ventilation. Roofs must have proper drain-
age and not hold “ponding water”. Rusty metal must be cleaned with a wire brush and primed with a metal primer/sealer before application of this
product. Repair all leaks and cracks with Sta-Kool
®
White Roof Patch and Universal Patching Fabric in accordance with product instructions.
Surfaces previously coated with aluminum, asphalt or tar should be allowed to cure for a minimum of one summer season prior to coating with this
product. Surfaces with mildew growth or stains must be cleaned with a bleach solution (2 parts water to one part bleach). Be certain all surfaces are
thoroughly rinsed and dry prior to applying coating. Do Not Thin.
APPLICATION: Surface and air temps must be 50°F and higher for a 24 hour period. DO NOT apply if heavy dew or rain is expected within 24-48
hours. Apply on clear, sunny day in morning hours with a professional airless paint sprayer or a 3/4” nap exterior paint roller. First, apply one coat
over all seams and joints. Allow to cure for one hour or until dry, then apply two (2) uniform coats over entire surface, avoiding excessive rolling. Two
full coats are needed for all applications. Apply second coat perpendicular to rst coat. Allow at least 24 hours between coats and 24-48 hours for
full curing. DO NOT apply to at surfaces, poor drainage areas, or where ponding water will exist.
COVERAGE RATE: Approximately 50-75 sq. ft. per gal. per coat. Total coverage for two (2) coat application is 25-35 sq. ft. per gallon.
NOTE: If roof becomes hot (over 100° F) during application, lightly mist roof surface with water spray to prevent coating from drying too fast. Remove
any excess or puddling water prior to coating. If roof surfaces become soiled as they age, due to the elements, Elastomeric can be cleaned with a
mild water and bleach solution. Excess scrubbing should be avoided. If coloring is desired, a typical addition of 3-4 ounces per gallon of universal
colorant can be added, which will result in light pastel colors. Note: Color tinting will disclaim warranty.
CLEAN-UP: Clean tools with soap and water.
PRECAUTIONS: For exterior use only. DO NOT allow product to freeze. Protective clothing and eyewear should be used during application of
these products. When transporting this product, ensure that lid is tight and pail secure and upright. DO NOT allow pail to tumble as this may cause
lid to loosen and leakage to occur. Do not transport on passenger seats or inside the passenger compartment of any vehicle. Store product in the
cargo area of vehicle, and secure over protective cloths to prevent damage due to accidental spills. For longest life, store in controlled environment,
35°F-80°F. DO NOT store in direct sunlight. DO NOT store at temperatures above 110°F. Close container after use. DO NOT reuse empty containers.
Do not use on EPDM, TPO, PVC or other rubber/synthetic surfaces. Do not use in drinking water or food systems.
WARRANTY AND DISCLAIMER: Sta-Koo
l®
780 Siliconized Acrylic, White Elastomeric Roof Coating is guaranteed to form a protective coating
to your roof, for a period of ten (10) years from the date of purchase. This warranty is only applicable when this product is applied according to our
directions, in two coats, and used with other Sta-Kool
®
products. This warranty does not cover at roofs, or poor drainage surfaces where ponding
water exists. All surfaces must maintain a minimum slope of 1/4” per foot to be eligible for warranty. If the coating does not perform as stated during
the guarantee period, we will provide, with sales receipt, the original purchaser with replacement coating to repair the affected part of the roof. Fail-
ures due to acts of God, re, structural defects or causes beyond our control are excluded from this guarantee. The manufacturer is not responsible
for any labor, property or other consequential damages or costs incurred in the original or any replacement application. Except as stated above, we
make no warranties or guarantees, expressed or implied, and none should be inferred.
Sta-Kool
®
780 Siliconized Acrylic, White Elastomeric Roof Coating is a high quality, exible, white acrylic roof coating. Product
is enhanced with silicone, for improved water resistance, adhesion and life expectancy. Product resists cracking, peeling, while
offering tremendous durability, and long term life. The coating forms a durable protective barrier which reects the sun’s heat and
destructive UV rays. This product can help lower cooling costs in buildings that use air conditioning. This product will reduce the
surface temperature of the roof surface, which lowers the amount of heat gain that penetrates through the roof surface. This allows
cooling equipment to run more efciently.
• Bright Reective Finish Protects Roofs
• Expands And Contracts Up To 300%
• Can Help Lower Cooling Costs*
• Sta-Kleen Brighter White Finish
* This product can help lower cooling costs in buildings that use air conditioning. This product will reduce the temperature of the roof surface, which lowers the amount of
heat gain that penetrates through the roof surface.
Siliconized Acrylic
Cool Roof Elastomeric Coating
780