Installation Guide

1
2
Pullout Kitchen Mixer
3
4
min.
80mm
min.
15mm
max.
3Nm
NOTE!
Abey Australia Pty Limited
57-81 Abey Road
Cobblebank 3338
PHONE: [phone]
Working Specifications
Maximum : Temperature - 80°C
Pressure - 500kpa
Where normal work ing pressures exceed the maximum
stated above, pressure limting valve should be installed as
excessive pressure may damage the tap and void warrant
y
.
Minimum : Temperature - 1°C
Pressure - 150 kpa
Recommended operating pressure: 150 to 500kpa.
NOTE:
This mixer must be installed with isolating stop taps in
accordance with local authority installation codes. All Abe
y
mixers must be installed by a licensed plum
ber, failure to do
so may void warranty.
All Abey tap ware must be installed in
accordance with AS/NZS 3500 series.
Care and Maintenance
The materials and workmanship of the tapware is of high
quality and in order to maintain its appearance, it important is
not to wipe with abrasive cleaners. Cleaning of this product
should only be done with warm soap water on a regular basis.
1
2
All pipework must be thoroughly flushed prior to installation,
as foreign materials may block the flow .
Aerator insert housing must be retightened to prevent
removal by hand.
Notice
This tap is manufactured to standard
AS/NZS 3718.
300-450 mm
If the thickness of sink >35mm,
no need to use the mounting seat