INSTALLATION AND OPERATION MANUAL Production Griddle CG-48F, CG-60F, CG-72F

Part # 4520498 (01/08)Page 10
MAINTENANCE & CLEANING Continued
Don’ts
1. Do not use salt to clean the griddle surface. Salt is
corrosive and can cause pitting of the griddle.
2. Do not allow metal utensils (Spatula, scraper, etc.) to
nick and/or dent the surface of the griddle. The edges of
these utensils are sharp and will create divots that oil can
collect in and caramelize which will cause sticking.
3. Do not use the griddle as a hot top. A large pan or pot will
trap heat and can cause the griddle plate to warp.
4. Do not overheat the griddle to preheat faster. Preheating
only takes 15 – 20 minutes.
SERVICING
To ensure ecient and safe operation of the appliance it
is recommended that servicing be carried out at regular
intervals, the frequency of which will vary, depending on the
installation conditions and usage. Usually once per year is
adequate.
SAFETY
It is essential that the instructions in this booklet be strictly
followed for the safe and economical operation of the
equipment. If it is known or suspected that a fault exists on
the appliance then it must not be used until a competent
person has rectied the fault.
Servicing must be carried out by competent persons in
accordance with the law.