User's Manual
Table Of Contents
- Preface
- Getting Ready
- Find It and Go!
- Where To?
- My Locations
- Viewing the Map and Using the Tools
- Creating and Editing Routes
- Using The Logs
- Using Bluetooth® Wireless Technology Hands-free Features
- Traffic Information
- Customizing the Navigator III
- Appendix
- Removing Your Navigator III from the Motorcycle Mount
- Connecting to Your Computer
- Register Your Navigator III
- Updating the Software and Map Data
- Custom POIs (Points of Interest)
- Using the Optional Remote Control
- Technical Specifications
- Changing the Fuse
- Using a Remote GPS Antenna
- Navigator III Troubleshooting
- FCC Compliance
- Software License Agreement
- Declaration of Conformity
- Index
34 Navigator III Owner’s Manual
APPENDIX
APPENDIX
Removing Your Navigator III from the
Motorcycle Mount
1. Use the security screwdriver to loosen the screw on the top
of the cradle lock.
2. Lift the cradle lock up until it clicks.
3. Pull the BMW Motorrad Navigator III unit out of the mount.
4. Slide the power connector to the left to disconnect the
power cable.
Connecting to Your Computer
NOTE: Do not connect the USB cable to your computer until
you have loaded the USB drivers using the enclosed DVD-
ROM.
To update your software, load additional maps, or load Custom
POIs, connect your Navigator III to your computer using the USB
cable provided.
Step 1: Load the USB Drivers
Before connecting the USB cable to your computer, place the
enclosed DVD-ROM into your computer’s DVD-ROM drive.
If the DVD-ROM does not start automatically, click
Start and
then Run…. Type the letter of your DVD-ROM drive followed
by “setup” (example: “D:\setup”). Then press Enter. Follow the
on-screen instructions.
Step 2: Connect AC Power
Connect the enclosed AC power cable to the power connector
on the back of the Navigator III Connect the end to an available
electrical outlet.