User's Manual

ManualsBrandsGarmin International ManualsElectronicsLOW POWER COMMUNICATIONS TRANSMITTER

Heart Rate Monitor

subtitle if needed

instructions (EN)

Garmin

and the Garmin logo are trademarks of Garmin Ltd. or

its subsidiaries, registered in the USA and other countries. ANT

™

and ANT+

™

are trademarks of Garmin Ltd. or its subsidiaries.

These trademarks may not be used without the express permission

of Garmin. Other trademarks and trade names are those of their

respective owners.

IMAGE

January 2009 Printed in Taiwan

Part Number 190-00972-91 Rev. A

Summary of content (5 pages)

PAGE 1
Heart Rate Monitor subtitle if needed IMAGE instructions (EN) © 2009 Garmin Ltd. or its subsidiaries Garmin® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. ANT™ and ANT+™ are trademarks of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin. Other trademarks and trade names are those of their respective owners. January 2009 Printed in Taiwan Part Number 190-00972-91 Rev.
PAGE 2
EN WARNING: See the Important Safety and Product Information in the Garmin product box for product warnings and other important information. Positioning the Heart Rate Monitor The heart rate monitor is on standby and ready to send data. Wear the heart rate monitor directly on your skin, just below your breastplate. It should be snug enough to stay in place during your run. 1. Snap one side of the strap to the heart rate monitor module. 2.
PAGE 3
4. Turn on the Garmin compatible product, and bring it within range (3 m) of the heart rate monitor. Note: If the heart rate data is erratic or does not appear, you may have to tighten the strap on your chest or warm up for 5–10 minutes. Pairing the Heart Rate Monitor Pairing is the connecting of ANT+™ wireless sensors, like your heart rate monitor, with a Garmin compatible product.
PAGE 4
EN Caring for the Heart Rate Monitor Note: Unsnap the module before cleaning the strap. To prolong the life of your heart rate monitor, rinse the strap after every use. Hand wash the strap in cold water with a mild detergent after every five uses. Do not put the strap in a washing machine or a dryer. Battery Information WARNING: Do not use a sharp object to remove user‑replaceable batteries. Contact your local waste disposal department to properly recycle the batteries. 1.
PAGE 5
Technical Specifications Physical size: W × H × D: 11.5 × 1.4 × 0.5 in. (29.3 × 36.5 × 12.5 mm) Weight: 1.6 oz. (45 g) Water resistance: 98 ft. (30 m) Transmission range: approximately 9.8 ft. (3 m) Battery: user-replaceable CR2032 (3 volts) Perchlorate Material – special handling may apply. See www.dtsc.ca.gov/hazardouswaste /perchlorate. Battery life: approximately 4.5 years (1 hour per day) Operating temperature: from 23°F to 122°F (from -5°C to 50°C) Radio frequency/protocol: 2.