Sport PRO™ Owner’s Manual July 2015 Printed in Taiwan 190-01893-00_0A
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. Go to www.garmin.com for current updates and supplemental information concerning the use of this product. Garmin and the Garmin logo are trademarks of Garmin Ltd.
Table of Contents Getting Started............................................................... 1 Setting Up the Sport PRO System .............................................. 1 Device Overviews ....................................................................... 1 Sport PRO Handheld Device ................................................. 1 Sport PRO Dog Device .......................................................... 1 Attaching the Dog Collar Device to the Collar Strap ...................
Getting Started WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. Attaching the Dog Collar Device to the Collar Strap 1 With the buckle À facing outward, insert the end of the collar strap through the slot Á on the collar device. Setting Up the Sport PRO System Before you can use the Sport PRO system, you must set up the devices.
Move the dog collar device toggle switch to select the color associated with a dog collar device. The training keys control the dog collar device associated with the selected color. Fitting the Collar on Your Dog 2 Plug the power cable into a power source. The status LED is solid red when the collar is charging. 3 After the status LED turns solid green, remove the charging clip from the collar.
1 Select the correct contact point length for your dog's coat type: • For dogs with thicker coats, use the longer contact points. • For dogs with shorter coats, use the shorter contact points. 2 If necessary, use the included wrench to remove the contact points. Twist the contact points into the collar. 3 4 Tighten with the included wrench, but do not overtighten. When you put the collar on the dog, make sure the contact points are tight against the neck.
mode by enabling it from the handheld device (Enabling the BarkLimiter Feature from the Handheld Device, page 3). Hold CONTINUOUS, TONE, or VIBE for 4 seconds. The dog collar device returns to training mode. Enabling the Independent BarkLimiter Feature from the Dog Collar Device The dog collar device can operate independently as a bark correction device. You can enable the BarkLimiter feature in auto-rise mode directly from the dog collar device.
7 Verify the gasket is not damaged and is completely seated in the groove on the front half of the device. 8 Verify the USB gasket is not damaged and is completely positioned around the USB opening on the back half of the device. 9 While ensuring the battery wires are not pinched, hold the back plate and the device firmly together, and replace all security screws without tightening them. 10 Verify the back plate and the device are aligned with no gaps. 11 Tighten the screws evenly.
Index A accessories 5 B bark correction 3, 4 bark odometer 4 battery charging 1 replacing 4, 5 C charging collar 1 handheld 1 collar attaching strap 1 charging 1 contact points 1, 2 fitting 2 light 4 pairing 2 contact points 1, 2 D device, registration 5 dog status 3 training 2 training basics 3 training intensity levels 3 dog collar device 1, 2 I intensity level automatic 3 changing 3 choosing 3 K keys 1 P pairing, collar 2 power key 1, 2 product registration 5 R registering the device 5 replacing t
www.garmin.
