Standard Configuration HS3 port HS2 Port HS1 port Power Accessory port NMEA2k port 10meter Extension Cable Optional Configuration Please use same cable that was provided for VHF200.
Items listed below were sent for testing. VHF300 BASE Q’ty : 3 Handset with Audio input/output terminals Q’ty : 3 Speaker with Audio output terminals / White resin material Q’ty : 3 --Note-Please do not use the Handset which this arrangement was given for EMC TEST. --Note-Please do not use the Handset which this arrangement was given for EMC TEST. *4ohm dummy load is installed. *22 ohm dummy load is installed instead of speaker. *Speaker is not active. *Microphone is not active.
PTT 1. 2. Press to turn on power. Press and hold to turn off power. TX power setting mode. *Press the Left soft key to select TX power. 1. 2. 1st press to enter Squelch setting. 2nd press to enter Volume setting. “3.5mm Jack” for Audio input and output. --Note-Please do not use the Handset which this arrangement was given for EMC TEST.
Enter the Test Mode testing the Modulation of DSC . Step-1. Enter the Test Mode 1. Turn off power. 2. Press and hold “MENU” + “16”. Step-2 Enter the Key code Please enter the Key code as follow. 3 2 4 CLEAR>>Center softkey>>Left softkey>>Right sofykey Screen will be as right image. 1 155.
1 Testing of FSK modulation of DSC. 1.1 Set to DSC Modulation test Mode. 1. Change the Test Mode to “DSC MOD”. Press “-“ soft key to change the channel to CH70. 156.550 70 FSK 1.2 DSC MOD LEVEL:050 FSK:1300HZ PRESS OK + - Testing Y-state / 1300Hz modulation 1. Press PTT then Y-State / 1300HZ Signal will be transmitted. 156.550 70 FSK 1.3 DSC MOD LEVEL:050 FSK:1300HZ PRESS OK + - Testing B-state / 2100Hz modulation 1. Press “FSK” softkey to change FSK signal to the B-state. 2.
2 Testing of FSK modulation of ATIS. 2.1 Set to ATIS Modulation test Mode. 1. Change the Test Mode to “ATIS MOD”. Press “+“ or “-“ soft key to change the channel to CH01,CH02 or CH03. 156.800 02 ATIS MOD LEVEL:050 FSK:1300HZ PRESS OK FSK 2.2 + - Testing Y-state / 1300Hz modulation 2. Press PTT then Y-State / 1300HZ Signal will be transmitted. 156.800 02 ATIS MOD LEVEL:050 FSK:1300HZ PRESS OK FSK 2.3 + - Testing B-state / 2100Hz modulation 1.