User Manual
30 Edge 500 Owner’s Manual
ANT+ Sensors
For a list of third-party ANT+ sensors
that are compatible with the Edge, go
to www.garmin.com/intosports.
For calibration instructions specic
to your power meter, refer to the
manufacturer’s instructions.
Before you can calibrate your power
meter, it must be properly installed and
actively recording data.
1. Press and hold MENU.
2. Select Settings > Bike Settings
> [Bike 1] > ANT+ Power >
Calibrate.
3. Keep your power meter active by
pedaling until the message appears.
You can set seven custom power zones
using Garmin Connect. If you know
your FTP (functional threshold power)
value, you can enter it and allow the
software to calculate your power zones
automatically.
1. Press and hold MENU.
2. Select Settings > Bike Settings >
[Bike 1] > Power Zones.
The non-zero data-averaging setting
is available if you are training with
an optional power meter. The default
setting is to exclude zero values that
occur when you are not pedaling.
To turn the non-zero averaging on or
off, press and hold MENU, and select
Settings > Bike Settings > Data Avg.