User Manual
2
This product contains a lithium-ion battery�
See page 5 for important battery safety
information�
With your thumbnail, slide the battery
cover release tab
➊�
➌
➊
➋
Remove the battery cover ➋�
Locate the metal contacts on the end
of the lithium-ion battery�
Insert the battery ➌ so the metal
contacts on the battery align with
the metal contacts inside the battery
compartment�
Press the battery down into place�
Insert the battery cover into the
notches and press down�
The release tab locks the cover in
place�
You can purchase a replacement battery
(010-10840-00) at http://buy�garmin�com�
You can use the sensor while you are
charging it�
Plug the small end of the power cable
into the mini-USB connector on the
end of the sensor�
Plug the other end of the power cable
into an appropriate source of power for
the cable type�
It takes about three hours to charge the
battery� A fully charged battery lasts about
12 hours�
: If the battery has not been charged
for a long period of time, remove the
battery, connect the cable to the device
and a power source, and then replace the
battery� The battery will charge as usual�