Owner's Manual

4
Connect the adapter
À
to the headlight.
5
Insert the screw
Á
, and hand tighten.
6
Align the tabs on the adapter with the notches of the mount.
The lever
Â
must be in the open position.
7
Insert the device into the mount.
8
Snap the lever to the closed position to lock the device into
the mount.
The lever must be flush with the base.
9
Adjust the headlight angle, and use the 4 mm hex key to
tighten the screw.
NOTE: You should check the tightness of the screw
periodically.
Device Overview
À
Device
key
Hold for 1 sec. to turn the device on.
Hold for 2 sec. to turn the device off.
Hold to enter pairing mode (Pairing Your Bike Light with
Your Edge 820, page 2).
Select to change operating modes.
Á
Status
LED
View device status (Bike Light Status LEDs, page 2).
Turning On the Device
1
Hold the device key for 1 second.
The first time you turn on the device, it enters pairing mode.
The status LED flashes purple. The device can be paired with
a wireless remote or Edge device.
2
Hold the device key for 2 seconds to turn off the device.
The next time you turn on the device, it is in high intensity
mode.
Bike Light Status LEDs
LED Activity Status
Solid red An error occurred while charging, or the
device shut down to prevent overheating.
Flashing red The battery is low.
Flashing green The battery is charging.
Solid green Charging is complete.
Flashing blue The device is in smart mode and can be
controlled by a paired wireless remote or
Edge device.
Flashing purple The device is in pairing mode.
Alternating blue and
green
The device is uploading software.
Device Settings
You can remotely control your Varia devices and customize
settings using your compatible Edge device. This section
contains instructions for the Edge 820 device. Other compatible
Edge devices use similar settings.
Pairing Your Bike Light with Your Edge 820
1
Bring the Edge device within range (1 m) of the sensor.
NOTE: Stay 10 m (33 ft.) away from other ANT+
®
bike lights
while pairing.
2
Turn on the Edge device.
3
Select > Settings > Sensors > Add Sensor > Search
All.
4
While the headlight is turned off, hold the Varia device key for
2 seconds to enter pairing mode.
The status LED flashes purple, and the headlight turns on.
The device is in pairing mode for 5 minutes or until you press
the device key.
5
Select your sensor.
When the sensor is paired with your Edge device, the status
icon appears solid on the connections screen.
Viewing the Connections Screen
The connections screen displays the status of the GPS, ANT+
sensors, and wireless connections.
From the home screen or a data screen, swipe down from
the top of the screen.
The connections screen appears. A flashing icon means the
device is searching.
2 Device Settings