VARIA UT800 ™ Owner’s Manual
© 2017 Garmin Ltd. or its subsidiaries All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. Go to www.garmin.com for current updates and supplemental information concerning the use of this product.
Table of Contents Introduction.....................................................................1 Installing the Out-Front Mount .................................................... 1 Installing the Helmet Mount ........................................................ 1 Device Overview ......................................................................... 2 Turning On the Device ................................................................ 2 Bike Light Status LEDs ..................................
Introduction WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. The device is intended for outdoor use. Without proper airflow during use, the device may become hot. Handle with care. Installing the Out-Front Mount You can use the out-front mount to install the headlight and your Edge device. Garmin recommends that you adjust the mount for the Edge viewing angle before you install and adjust the headlight angle.
The first time you turn on the device, it enters pairing mode. The status LED flashes purple. The device can be paired with a wireless remote or Edge device. 2 Hold the device key for 2 seconds to turn off the device. The next time you turn on the device, it is in high intensity mode. Bike Light Status LEDs 4 Connect the adapter to the headlight. 5 Insert the screw , and hand tighten. 6 Align the tabs on the adapter with the notches of the mount.
Customizing Headlight Settings with Your Edge Device Before you can customize Varia device settings with your Edge device, you must pair the devices (Pairing Your Bike Light with Your Edge 830 or 1030, page 2). 1 From the Sensors menu, select Lights. 2 Select an option: • Select Enable to enable the light network. • Select Network Options > Light Mode to set the light intensity mode for all lights in your network (Light Mode Settings, page 3).
Troubleshooting Charging the Device WARNING This device contains a lithium-ion battery. See the Important Safety and Product Information guide in the product box for product warnings and other important information. NOTICE To prevent corrosion, thoroughly dry the USB port, the weather cap, and the surrounding area before charging or connecting to a computer. NOTE: The device does not charge when outside the approved temperature range (Specifications, page 3). 1 Pull up the weather cap from the USB port.
When the sensor is paired with your Edge device, the status icon appears solid on the connections page. Pairing the Remote with Your Varia Device The first time you connect the Varia remote to your Varia device, you must pair the remote with your device. 1 Bring the remote within 1 m (3 ft.) of the device. NOTE: You must stay 10 m (33 ft.) away from other ANT+ sensors while pairing. 2 While the headlight is turned off, hold the Varia device key for 2 seconds to enter pairing mode.
Index A accessories 4 ANT+ sensors 2 B battery 3, 4 charging 4 brightness 3, 4 C charging 4 cleaning the device 4 customizing the device 2 D device, care 4 E Edge 2–4 G Garmin Express, updating software 4 GPS, signal 2 I installing 1 K keys 2 M mounting the device 1 P pairing 2, 4 remote control 5 R remote control, pairing 5 resetting, device 4 S satellite signals 2 settings 3 smartphone 2 software, updating 4 specifications 3 speed 3 T temperature 4 troubleshooting 4 6 Index
support.garmin.
