Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Introduction
- Training
- Navigation
- Bluetooth Connected Features
- ANT+ Sensors
- History
- Customizing Your Device
- Device Information
- Troubleshooting
- Resetting the Device
- Maximizing Battery Life
- Improving GPS Satellite Reception
- My device is in the wrong language
- Temperature Readings
- Replacement O-rings
- Viewing Device Information
- Updating the Software Using Garmin Connect Mobile
- Updating the Software Using Garmin Express
- Product Updates
- Getting More Information
- Specs
- Appendix
- Index
- Quick Start Manual
- Edge Remote Instructions
- Out-Front Mount Instructions
- Warranty
6
If necessary, use the 2 mm hex key to remove the two
screws on the back side of the mount
Ã
, remove and rotate
the connector, and replace the screws to change the
orientation of the mount.
7
Replace and tighten the screw on the handlebar connector.
NOTE: Garmin recommends tightening the screw so the
mount is secure, with a maximum torque specification of
7 lbf-in. (0.8 N-m). You should check the tightness of the
screw periodically.
8
Align the tabs on the back of the Edge device with the bike
mount notches
Ä
.
9
Press down slightly and turn the Edge device clockwise until
it locks into place.
Acquiring Satellite Signals
The device may need a clear view of the sky to acquire satellite
signals. The time and date are set automatically based on the
GPS position.
1
Go outdoors to an open area.
The front of the device should be oriented toward the sky.
2
Wait while the device locates satellites.
It may take 30–60 seconds to locate satellite signals.
Using the Backlight
• Select any key to turn on the backlight.
• Select to adjust the backlight brightness.
• From the home screen, select one or more options:
◦ To adjust the brightness, select > Brightness >
Brightness.
◦ To adjust the timeout, select > Brightness > Backlight
Timeout and select an option.
Training
Going for a Ride
If your device was packaged with an ANT+ sensor, they are
already paired and can be activated during initial setup.
1
Hold to turn on the device.
2
Go outside, and wait while the device locates satellites.
The satellite bars turn green when the device is ready.
3
From the home screen, select .
4
Select an activity profile.
5
Select to start the timer.
NOTE: History is recorded only while the timer is running.
6
Select or for additional data screens.
7
If necessary, select to view menu options such as alerts
and data fields.
8
Select to stop the timer.
TIP: Before you save this ride and share it on your Garmin
Connect account, you can change the ride type. Accurate
ride type data is important for creating bike friendly courses.
9
Select Save Ride.
Using the Shortcut Menu
Shortcut menu options are available for data screens and
accessory features. During a ride, appears on the data
screens.
Select to view the shortcut menu options.
Using Virtual Partner
®
Your Virtual Partner is a training tool designed to help you meet
your goals.
1
If necessary, enable the Virtual Partner screen for the activity
profile (Customizing the Data Screens, page 16).
2
Go for a ride.
3
Select to view the Virtual Partner screen to see who is
leading.
4
If necessary, select > Virtual Partner Speed to adjust the
speed of the Virtual Partner during your ride.
Segments
Following a segment: You can send segments from your
Garmin Connect account to your device. After a segment is
saved to your device, you can follow the segment.
NOTE: When you download a course from your Garmin
Connect account, all segments in the course are downloaded
automatically.
Racing a segment: You can race a segment, trying to match or
exceed your personal record or other cyclists who have
ridden the segment.
Training 3