User Manual

Device Information 13
2 Plug the large end of the USB cable into a USB
charging port.
3 Charge the device completely.
Tips for Charging Your Device
y Connect the charger securely to the device to
charge it using the USB cable (Charging the Device,
page12).
You can charge the device by plugging the USB
cable into a Garmin approved AC adapter with
a standard wall outlet or a USB port on your
computer.
y View the remaining battery graphic on the device
information screen (Viewing Device Information,
page13).
Device Care
NOTICE
Avoid extreme shock and harsh treatment, because it
can degrade the life of the product.
Do not use a sharp object to clean the device.
Never use a hard or sharp object to operate the
touchscreen, or damage may result.
Avoid chemical cleaners, solvents, and insect
repellents that can damage plastic components and
finishes.
Thoroughly rinse the device with fresh water after
exposure to chlorine, salt water, sunscreen, cosmetics,
alcohol, or other harsh chemicals. Prolonged exposure
to these substances can damage the case.
Keep the leather band clean and dry. Avoid swimming
or showering with the leather band. Exposure to water
or sweat can damage or discolor the leather band.
Use silicone bands as an alternative.
Do not place in high temperature environments, such
as a clothes dryer.
Do not store the device where prolonged exposure
to extreme temperatures can occur, because it can
cause permanent damage.
Cleaning the Device
NOTICE
Even small amounts of sweat or moisture can cause
corrosion of the electrical contacts when connected
to a charger. Corrosion can prevent charging and data
transfer.
1 Wipe the device using a cloth dampened with a
mild detergent solution.
2 Wipe it dry.
After cleaning, allow the device to dry completely.
TIP: For more information, go to Garmin.com.sg/legal/
fit-and-care.
Cleaning the Leather Bands
1 Wipe the leather bands with a dry cloth.
2 Use a leather conditioner to clean the leather
bands.
Changing the Bands
The device is compatible with 20 mm wide, standard,
quick- release bands.
1 Slide the quick-release pin on the spring bar to
remove the band.
2 Insert one side of the spring bar for the new band
into the device.
3 Slide the quick-release pin, and align the spring bar
with the opposite side of the device.
4 Repeat steps 1 through 3 to change the other
band.
Viewing Device Information
You can view the unit ID, software version, and
regulatory information.
1 Hold the touchscreen to view the menu.
2 Select > .
3 Swipe to view the information.
Specifications
Battery type
Rechargeable, built-in lithium-ion
battery
Battery life Up to 5 days in smart mode