Owner's Manual

3 Using an appropriate drill bit, drill a hole for the camera cable to enter the vehicle.
4 Feed the camera cable through the hole, and route it to the transmitter location.
5 Adjust the angle of the camera, and tighten the hex screws using the included hex key.
6 Apply RV sealant around the cable where it enters the vehicle (optional).
Mounting the Camera Directly on a Vehicle with Screws
Before you permanently mount the camera, you should test the mounting location for the optimal view for your
vehicle (Testing the Camera and Transmitter Location, page4).
If you have already connected the camera to the bracket, you must disconnect the camera from it.
1 Place the bracket directly on the surface of a vehicle, mark the locations of the two holes on the bracket
, and secure the bracket to the vehicle using the included self-tapping screws.
2 Place the camera in the bracket, and determine the best place for the camera cable to enter the vehicle.
3 Using an appropriate drill bit, drill a hole for the camera cable to enter the vehicle.
4 Feed the camera cable through the hole, and route it to the transmitter location.
5 Place the camera into the bracket.
6 Adjust the angle of the camera and tighten the hex screws using the included hex key.
7 Apply RV sealant around the cable where it enters the vehicle (optional).
5