• GAR MIN IPJ Heart Rate Monitor Instructions ..................... 2 Instructions du moniteur de fn3quence cardiaque ....................................................... 7 lstruzioni per Ia fascia cardia ....................... 13 Anweisungen fUr den Herzfrequenzsensor . 19 lnstrucciones del monitor de frecuencia cardiaca ....................................................... 25 lnstru~6es do monitor de ritmo cardlaco ..... 32 lnstructies voor de hartslagmeter ................
Heart Rate Monitor Instructions ~·wARR~NC~ See the Important Safety and Product Information guide in the product box for product warnings and other important information. -· ----------- Putting On the Heart Rate Monitor You should wear the heart rate monitor directly on your skin, just below your breastplate. It should be snug enough to stay in place during your activity. 1 Snap the heart rate monitor module CD onto the strap.
4 5 The contact patch should be on your left side. The hook@ should be on your right side. Wrap the strap around your chest, and connect the strap hook to the loop. NOTE: Make sure the care tag does not fold over. Bring the device within range (3m) of the heart rate monitor. After you put on the heart rate monitor, it is on standby and ready to send data.
• Stay 10 m away from other ANT+ sensors while pairing. After you pair the first time, your Garmin compatible device automatically recognizes the heart rate monitor each time it is activated. Tips for Erratic Heart Rate Data If the heart rate data is erratic or does not appear, you can try these tips. • Reapply moisture to the electrodes and contact patch. • • • • • • 4 You can use water, saliva, or electrode gel. Tighten the strap on your chest. Warm up for 5-1 0 minutes.
Caring for the Heart Rate Monitor You must unsnap and remove the module before cleaning the strap. A build up of sweat and salt on the strap can decrease the ability of the heart rate monitor to report accurate data. • • • • • • Go to www.garmin.com/HRMcare for detailed washing instructions. Rinse the strap after every use. Machine wash the strap after every seven uses. Do not put the strap in a dryer. When drying the strap, hang it up or lay it flat.
Replacing the Heart Rate Monitor Battery 1 Use a small Phillips screwdriver to remove 2 3 4 the four screws on the back of the module. Remove the cover and battery. Wait 30 seconds. Insert the new battery with the positive side facing up. NOTE: Do not damage or lose the 0-ring gasket. 5 Replace the back cover and the four screws. After you replace the heart rate monitor battery, you may need to pair it with the device aga1n.
Water resistance Water resistant to 98.4 ft. (30m) NOTE: This product does not transmit heart rate data while swimming. Operating temperature range From 23° to 122oF (from -5° to 50°C) Radio frequency/ protocol 2.4 GHz ANT+ wireless communications protocol Limited Warranty The Garmin standard limited warranty applies to this accessory. For more information, go to www.garmin.com/support/warranty.html.
FCC Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two (2) conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received including interference that may cause undesired operation. Industry Canada Compliance Category I radiocommunication devices comply with Industry Canada Standard RSS21 0. Category II radiocommunication devices comply with Industry Canada Standard RSS31 0.
Garmin®, and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. ANT+™ is a trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin. © 2013 Garmin Ltd. or its subsidiaries Garmin International, Inc. 1200 East 151 st Street Olathe, Kansas 66062, USA Garmin (Europe) Ltd. Liberty House, Hounsdown Business Park Southampton, Hampshire, S040 9LR UK Garmin Corporation No.