User Manual
Table Of Contents
- Table of Contents
- Getting Started
- Installation
- Installing the Magnetic Mount in Your Vehicle
- Connecting the Mount to Vehicle Power
- Camera Mounting Considerations
- Installing the Polarizing Filter on the Camera
- Installing the Remote Cam on Your Windshield
- Connecting the Camera Cable
- Connecting the Device to the Magnetic Mount
- Installing the Screw-Down Ball Mount on the Dashboard
- Device Overview
- Catalyst App
- Starting a Drive Session
- Reviewing Drive Sessions
- Settings
- Device Information
- Device Maintenance
- Troubleshooting
- The suction cup will not stay on my windshield
- The mount does not hold my device in place while I drive
- My device is not acquiring satellite signals
- The device does not charge in my vehicle
- My battery does not stay charged for very long
- My camera feels warm while it is operating
- My video recordings are blurry
- Appendix
Getting Started
WARNING
See the Important Safety and Product Information guide in the product box for product warnings and other
important information.
This device is only intended for recreational use in a circuit environment. Never use this device on public
roadways. Failure to follow this warning may result in an accident causing property damage, serious personal
injury, or death. You are responsible for using this device in a safe and prudent manner.
The first time you turn on your device, it guides you through the initial setup steps with on-screen prompts. You
should complete these steps before using the device for the first time.
1 Turn on the device, and follow the on-screen instructions.
2 Update your device software (Updating Software Using a Wi‑Fi Network, page 26).
Installation
Installing the Magnetic Mount in Your Vehicle
WARNING
This product contains a lithium-ion battery. To prevent the possibility of personal injury or product damage
caused by battery exposure to extreme heat, store the device out of direct sunlight.
Both the device and its mount contain magnets. Under certain circumstances, magnets may cause interference
with some internal medical devices and electronic devices, including pacemakers, insulin pumps, or hard drives
in laptop computers. Keep the device away from medical devices and electronic devices.
1 Clean and dry your windshield and the suction cup with a lint-free cloth.
2 Press the suction cup to the windshield, and flip the lever .
3 Connect the ball of the suction cup mount and the ball of the powered magnetic mount to the double-
socket arms .
4 Connect the double-ball link to both double-socket arms.
5 Tighten the knobs on both double-socket arms slightly.
6 If necessary, rotate the powered magnetic mount so the Garmin
®
logo faces right-side up, and adjust the
mount for better viewing and operation.
7 Tighten the knobs to secure the mount.
Getting Started 1