User Manual
Table Of Contents
- Table of Contents
- Introduction
- Training
- Ride Data
- Device Information
- Other Compatible Devices
- Appendix
Replacing the Batteries
WARNING
See the Important Safety and Product Information guide in the product box for product warnings and other
important information.
Each Rally 200 pedal uses one CR1/3N battery.
NOTE: Garmin recommends replacing all of the batteries at the same time. Do not mix the battery types.
1 Use a 4 mm hex key to remove the battery cover .
2 Remove the battery.
3 Wait 5 to 10 seconds.
4 Insert the new battery into the battery cover, observing polarity.
5 Replace the battery cover, and hand tighten it.
NOTE: Do not damage or lose the O-ring gasket.
6 Use a 4 mm hex key to tighten the battery cover to 3.6 lbf-ft. (5 N-m).
The LED displays one short green flash followed by one long red flash.
Device Information 13