User Manual
Table Of Contents
- Table of Contents
- Introduction
- Training
- Ride Data
- Device Information
- Other Compatible Devices
- Appendix
Overhauling the Rally Pedals
You can disassemble and reassemble the pedal spindles to clean and grease the components.
NOTICE
Garmin recommends changing one pedal at a time taking care to keep track of the small screws and seals. You
must obtain a 4 mm hex key, PH 00 screwdriver, 15 mm pedal wrench, 12 mm socket with an outer diameter
that is less than 17 mm (typically a
1
/
4
in. drive) on a torque wrench, and bike grease. Use care not to damage
any of the Rally components.
NOTE: If you have the single-sided Rally system, the right pedal has no battery carriage.
1 Use a 15 mm pedal wrench to remove the pedals.
NOTE: The left pedal spindle has a left-handed (reverse) thread attaching it to the crank arm.
2 Use a 4 mm hex key to remove the battery cover .
3 Set the battery cover and battery aside.
4 Use a small Phillips screwdriver (PH 00) to remove the two screws from inside the battery carriage .
5 Remove the battery carriage.
14 Device Information