User Manual

6 While securely holding the wrench flats with a pedal wrench, use the 12 mm socket wrench to unscrew the
spindle nut .
NOTE: The right pedal has a black spindle nut and a reverse thread. The left pedal has a silver spindle nut.
The left spindle has a line on the wrench flats.
7 Slide the spindle out of the pedal body.
8 Remove the inner seal and outer seal from inside the pedal body.
NOTE: Both seals are cone shaped to fit the tapered spindle .
9 Remove all old grease from the components.
10 Insert the inner seal into the pedal body.
You should press it down so it is flush with the bearing.
11 Slide the outer seal on to the spindle.
12 Apply bike grease to the bearing inside the pedal body.
13 Apply a layer of bike grease to the spindle.
14 Insert the spindle into the pedal body.
The outer seal and the top of the spindle should be flush with the pedal body cartridge.
15 Replace the spindle nut.
16 While securely holding the wrench flats with a pedal wrench, use the 12 mm socket wrench to torque the
spindle nut to 7 lbf-ft. (10 N-m).
WARNING
To ensure that the spindle nut stays in place, you must tighten it to the recommended torque specification.
Failure to properly tighten the nut could cause the pedal to fall off during a ride, which could result in property
damage or serious bodily injury or death.
17 Replace the battery carriage and two screws.
18 Replace the battery and battery cover, and hand tighten it.
NOTE: Do not damage or lose the O-ring gasket.
19 Use a 4 mm hex key to tighten the battery cover to 3.6 lbf-ft. (5 N-m).
The LED displays one short green flash followed by one long red flash.
20 Install the pedals on your bike (Installing the Pedals, page 2).
Rally Storage
If you are transporting your bicycle or not using Rally for an extended period of time, Garmin recommends
removing Rally and storing it in the product box.
Other Compatible Devices
Edge 530 Instructions
Pairing Rally with the Edge 530
1 Bring the Edge device within 3 m (10 ft.) of the sensor.
NOTE: Stay 10 m (33 ft.) away from other riders' sensors while pairing.
2 Select Menu > Settings > Sensors > Add Sensor.
3 Rotate the pedals a few times in order to activate the Rally system.
4 Select your sensor.
5 Select Add Sensor.
When the sensor is paired with your device, the sensor status is Connected. You can customize a data field
to display power data.
Other Compatible Devices 15