User Manual
Table Of Contents
- Table of Contents
- Introduction
- Training
- Ride Data
- Device Information
- Other Compatible Devices
- Appendix
Changing Your Rally Pedals
NOTICE
Garmin recommends changing one pedal at a time taking care to keep track of the small screws and seals. You
must obtain a 4 mm hex key, PH 00 screwdriver, 15 mm pedal wrench, 12 mm socket with an outer diameter
that is less than 17 mm (typically a
1
/
4
in. drive) on a torque wrench, and bike grease. Use care not to damage
any of the Rally components.
This procedure shows the Rally RS and the Rally XC pedals. The procedure is the same for any Rally series pedal
conversion.
NOTE: If you have the single-sided Rally system, the right pedal has no battery carriage.
1 Use a 15 mm pedal wrench to remove the Rally RS pedals.
NOTE: The left pedal spindle has a left-handed (reverse) thread attaching it to the crank arm.
2 Use a 4 mm hex key to remove the battery cover .
3 Set the battery cover and battery aside.
4 Use a small Phillips screwdriver (PH 00) to remove the two screws from inside the battery carriage .
5 Remove the battery carriage.
18 Appendix