User Manual

Resetting the Rally Pedals
If the device stops responding, you may need to reset it by disconnecting and reconnecting the battery cover.
This does not erase any of your data.
1 Use a 4 mm hex key to remove the battery cover and battery.
2 Replace the battery and battery cover, and hand tighten it.
NOTE: Do not damage or lose the O-ring gasket.
3 Use a 4 mm hex key to tighten the battery cover to 3.6 lbf-ft. (5 N-m).
The pedal LED flashes red once.
Performing a Static Torque Test
NOTICE
The static torque test is intended for advanced cyclists and installation experts. This test is not required under
normal circumstances to achieve good results with the Rally system. This test is available for compatible Edge
devices.
Garmin recommends performing the static torque test a minimum of three times and averaging the reported
torque values.
1 Go to www.support.garmin.com.
2 Enter your product name.
3 Enter "torque test" to view the FAQ topic.
Following repeated static torque tests, if the reported torque value is consistently different than the expected
value, you can enter a scale factor for one or both pedals. The scale factor is stored in the pedal and adjusts the
power value that is calculated on the pedal. The scale factor is sent to the Edge device and stored on Edge
device.
Getting More Information
• Go to support.garmin.com for additional manuals, articles, and software updates.
• Go to buy.garmin.com, or contact your Garmin dealer for information about optional accessories and
replacement parts.
22 Appendix