User Manual
Table Of Contents
- Table of Contents
- Introduction
- Training
- Ride Data
- Device Information
- Other Compatible Devices
- Appendix
Shoe Cleats
Installing the Shoe Cleats for Rally RS and Rally RK
NOTE: The left and right cleats are the same.
1 Apply a thin layer of grease on the cleat bolt threads.
2 Align the cleat , washers , and bolts .
3 Use a 4 mm hex key to loosely attach each bolt to the sole of the shoe.
4 Adjust the cleat to the shoe in your preferred position.
This can be adjusted after a trial ride.
5 Tighten the cleat firmly to the shoe.
NOTE: Garmin recommends a torque of 4 to 6 lbf-ft. (5 to 8 N-m).
Introduction 5