User Manual
Table Of Contents
- Table of Contents
- Introduction
- Clocks
- Trucking
- Activities and Apps
- Training
- History
- Appearance
- Sensors and Accessories
- Map
- Phone Connectivity Features
- User Profile
- Safety and Tracking Features
- Health and Wellness Settings
- Navigation
- Power Manager Settings
- System Settings
- Device Information
- Troubleshooting
- Product Updates
- Getting More Information
- My device is in the wrong language
- Is my phone compatible with my watch?
- My phone will not connect to the watch
- Can I use my Bluetooth sensor with my watch?
- Restarting Your Watch
- Resetting All Default Settings
- Tips for Maximizing the Battery Life
- Acquiring Satellite Signals
- The temperature reading is not accurate
- Activity Tracking
- Appendix
Entering Wind Information for a Static Jump
1 Press GPS.
2 Select Jumpmaster > Static > Wind.
3 Enter a wind speed in knots and select Done.
4 Enter a wind direction in degrees and select Done.
Constant Settings
Select Jumpmaster, select a jump type, and select Constant.
Percent Max.: Sets the jump range for all jump types. A setting less than 100% decreases the drift distance to
the DIP, and a setting greater than 100% increases the drift distance. More experienced jumpmasters may
want to use smaller numbers, and less experienced skydivers may want to use larger numbers.
Safety Factor: Sets the margin of error for a jump (HAHO only). Safety factors are usually integer values of two
or greater, and are determined by the jumpmaster based on specifications for the jump.
K-Freefall: Sets the wind drag value for a parachute during freefall, based on the parachute canopy rating (HALO
only). Each parachute should be labeled with a K value.
K-Open: Sets the wind drag value for an open parachute, based on the parachute canopy rating (HAHO and
HALO). Each parachute should be labeled with a K value.
K-Static: Sets the wind drag value for a parachute during a static jump, based on the parachute canopy rating
(Static only). Each parachute should be labeled with a K value.
Surfing
NOTE: This feature is only available on Instinct 2 - Surf Edition models.
You can use the surfing activity to record your surfing sessions. After your session, you can view the number of
waves, longest wave, and maximum speed.
1 From the watch face, press GPS.
2 Select Surf.
3 Wait on the beach until your watch acquires GPS signals.
4 Press GPS to start the activity timer.
5 After you complete your activity, press GPS to stop the activity timer.
6 Select Save to review the summary of your surfing session.
Activities and Apps 23