Garmin Dash Cam™ 30/35 Owner’s Manual October 2015 Printed in Taiwan 190-01925-00_0A
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. Go to www.garmin.com for current updates and supplemental information concerning the use of this product. Garmin and the Garmin logo are trademarks of Garmin Ltd.
Table of Contents Getting Started............................................................... 1 Installing the Memory Card ......................................................... 1 Device Overview ......................................................................... 1 Installing the Mount onto Your Windshield ................................. 1 Installing and Setting Up the Dash Cam ..................................... 1 Turning On the Device Manually ..............................................
Getting Started WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. 1 Clean the windshield using water or alcohol, and a lint-free cloth. The windshield must be free of dust, wax, oils, or coatings. 2 Remove the protective film from the mount adhesive. Installing the Memory Card The camera requires a microSD™ or microSDHC memory card of up to 64GB with a speed rating of class 10 or higher.
5 Adjust the position of the camera to capture the desired field 1 Select > Gallery. 2 Select an option: Turning On the Device Manually • To view videos you saved manually, select Saved Videos. • To view videos saved when the device detected an event, select Events. • To view recent video footage that has not been saved, select Unsaved Videos. • To view a saved photo, select Photos. 3 Select a video or photo. of view.
Forward Collision Warning System WARNING The forward collision warning system (FCWS) feature is for information only and does not replace your responsibility to observe all road and driving conditions, abide by all traffic regulations, and use safe driving judgment at all times. The FCWS relies on the camera to provide a warning of upcoming vehicles and, as a result, may have limited functionality in low visibility conditions. NOTE: This feature is not available in all areas or for all product models.
TIP: You may need to use a coin to remove the end piece. 2 Remove the end piece, the silver tip Á, and the fuse Â. 3 Insert a new fast-blow fuse that has the same current, such as 1 A or 2 A. 4 Place the silver tip in the end piece. 5 Push in the end piece and rotate it 90 degrees clockwise to lock it back into the vehicle power cable Ã. Removing the Camera Mount from the Windshield The adhesive mount is intended for a long-term installation and can be difficult to remove. 1 Firmly grip the mount.
www.garmin.