Quick Start Guide

2. Attach the bike mount securely using two cable ties.
Note: Make sure the cable ties are threaded through both parts
of the bike mount.
3. Align the Edge with the bike mount so that the unit is vertical.
4. Slide the unit left until it snaps into place.
To release the unit:
Press down on the release lever, and slide the unit to the right.
➊
Charge the Battery
1. On the back of the Edge, pull up the weather cap from the
mini-USB port. Make sure that this area is completely dry to
prevent corrosion.
2. Plug the mini-USB end of the charger into the mini-USB port on
the unit.
3. Plug the A/C charger into a standard wall outlet. Charge the
Edge for at least 3 hours before using. When the battery is
completely charged, it can run for approximately 12 hours
before recharging.
➌
Configure the Edge
When you first turn on your Edge, the following setup screens appear.
Follow the on-screen instructions.
To configure your Edge:
➋
Mount the Edge
You can install the bike mount to the stem or handlebars. The stem
installation (shown here) provides a more sturdy location. Make sure
that the Edge is facing up for the best GPS reception.
To install the Edge on your bike stem:
1. Place the wedge on the bike stem, and then place the bike
mount on the wedge. Make sure the release lever is on the left.
For horizontal bars: Separate and remove the top part of the
mount, turn it 90 degrees, and replace. Continue with step 2.
For bars with a diameter less than 1 in (25.4 mm): Place
the additional rubber pad under the bike mount to increase the
diameter of the bar. The rubber pad also keeps the mount from
slipping. Continue with step 2.
Getting Started
1
power
• Press and hold to turn unit on/off.
• Press to turn backlight on/off.
2
mode
• Press to switch modes.
• Press to return to the previous page.
3
reset/lap
• Press and hold to reset the timer.
• Press to create a new lap.
4
start/stop
Press to start/stop the timer.
5
up/down
• Press to highlight options.
• Press to scroll through menus and data fields.
• Press to adjust contrast when on the Satellite page.
6
enter
Press to select options and to acknowledge messages.
Note: If the Edge locks up, press mode and reset/lap simultaneously
to reset the unit.





































1
2
3
4
6
5
mini-USB port under
weather cap
➍
Acquire Satellites
Acquiring satellite signals may take 30–60 seconds. For
troubleshooting information, refer to the owner’s manual.
To acquire satellite signals:
Go outdoors to an open area. Press and hold the
Power button to turn on the Edge.
On the Satellite page, the available satellites are
flashing while the Edge searches for satellite
signals. Acquired satellites and each corresponding
bar below change to solid. The GPS accuracy
appears at the top of the page.
Wait while the Edge searches for satellites. For best
reception, make sure the Edge is facing up. Stand
still in an open area, and do not begin moving until
the Satellite page disappears. After the Satellite
page disappears, you can begin your ride.
Screens 4 and 5
apply to Edge 305
only.
1
2
3
4
5
release lever
wedge
(optional)
bike mount

release lever
cable ties