Edge 510 ® Quick Start Manual December 2012 190-01531-01_0B Printed in Taiwan
Introduction WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. Always consult your physician before you begin or modify any exercise program. Getting Started When using your device the first time, you should complete these tasks to set up the device and learn about the basic features. 1 Install your device using the standard mount (page 2) or the out-front mount (page 2). 2 Turn on the device (page 3).
8 Press down slightly and turn the Edge clockwise until it locks • Select to close the page and return to the previous page. • Select to return to the previous page. • Select to return to the home screen. • Select and to scroll. • Select to view the connections page. • Select to delete an item. Viewing the Connections Page The connections page displays the status of the satellite signals, ANT+ sensors, and your smartphone. From the home screen, select the status bar at the top of the page.
Going for a Ride Before you can record speed and distance, you must locate satellite signals (page 3) or pair your device with an optional ANT+ sensor. NOTE: History is recorded only while the timer is running. 1 From the home screen, select RIDE. 2 Wait while the device locates satellites. 3 Select to start the timer. Share your activities: You can email your activities to others, or post links to your activities on your favorite social networking sites.
When the device memory is full, a message appears. The device does not automatically delete or overwrite your history. Upload your history to Garmin Connect periodically to keep track of all your ride data. Viewing Your Ride 1 From the home screen, select 2 Select Last Ride or All Rides. 3 Select an option. Deleting History 1 From the home screen, select 2 Select an option: > Rides. Installing the GSC 10 NOTE: If you do not have a GSC 10, you can skip this task.
The LED turns red, then green. 10 Pedal to test the sensor alignment. The red LED blinks each time the pedal magnet passes the sensor. The green LED blinks each time the spoke magnet passes the sensor arm. NOTE: The LED blinks for the first 60 passes after a reset. Select Reset again if you require additional passes. 11 When everything is aligned and working correctly, tighten the cable ties, the sensor arm, and the spoke magnet. Garmin recommends that the torque is 1.9 to 2.4 lbf-in. (0.21 to 0.
www.garmin.com/support 913-397-8200 1-800-800-1020 0808 2380000 +44 870 850 1242 1-866-429-9296 43 (0) 3133 3181 0 00 32 2 672 52 54 00 45 4810 5050 00 358 9 6937 9758 00 331 55 69 33 99 0180 5 / 42 76 46 - 880 00 39 02 3669 9699 0800-0233937 815 69 555 00800 4412 454 +44 2380 662 915 00 35 1214 447 460 00 34 902 007 097 00 46 7744 52020 Garmin International, Inc. 1200 East 151st Street Olathe, Kansas 66062, USA Garmin (Europe) Ltd.
