User Manual

Garmin G1000 Pilot’s Guide for the Quest Kodiak 100
190-00590-01 Rev. B
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
40
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
40
Garmin G1000 Pilot’s Guide for the Quest Kodiak 100
AUX - UTILITY PAGE
For flight planning purposes, timers, trip statistics, and a scheduler feature are provided on the AUX -
Utility Page. The timers available include a stopwatch-like generic timer, a total time in flight timer, and a
record of the time of departure. Trip statistics—odometer, trip odometer, and average trip and maximum
groundspeeds—are displayed from the time of the last reset. Refer to the Additional Features section for a
dicussion on the Scheduler feature.
Figure 1-37 Utility Page
ti m e r s
The G1000 timers available include:
•Stopwatch-likegenerictimers(availablefromthePFDTimer/ReferencesWindowandontheMFDAUX
- Utility Page)
•Total-time-in-ighttimer(MFDAUX-UtilityPage)
•Timesincedeparture(MFDAUX-UtilityPage)
The generic timer can be set to count up or down from a specified time (HH:MM:SS). When the
countdown on the timer reaches zero the digits begin to count up from zero. If the timer is reset before
reaching zero on a countdown, the digits are reset to the initial value. If the timer is counting up when
reset, the digits are zeroed.
Setting the generic timer (PFD):
1) Press the TMR/REF Softkey.
2) Turn the large FMS Knob to select the timer field (hh/mm/ss).
3) Use the FMS Knob to enter the desired time and press the ENT Key.
4) With the UP/DN field highlighted, turn the small FMS Knob to select the timer counting direction (UP/DN) and
press the ENT Key.