Quick Start Manual
4 GHP 20 Installation Instructions
➊
NMEA 2000 drop cable, 6 ft. (2 m) (×2)
➋
NMEA 2000 power cable
➌
NMEA 2000 T-connector (×3)
➍
NMEA 2000 terminator, male
➎
NMEA 2000 terminator, female
NMEA 2000 extension cables are available if needed. Contact
your local Garmin dealer or Garmin Product Support for ordering
information.
• Safety glasses
• Drill and drill bits
• 3
1
/
2
in. (90 mm) hole saw
• Wire cutters/strippers
• Phillips and at screwdrivers
• Cable ties
• Waterproof wire connectors (wire nuts) or heat-shrink tubing and a
heat gun
• Marine sealant
• Portable or handheld compass (to test for magnetic interference
when determining the best location to install the CCU)
• Anti-seize lubricant (optional)
NOTE: Mounting screws are provided for the GHC 10 and the CCU. If
the provided screws are not appropriate for the mounting surface, you
must provide the correct types of screws.