GMI 20 ™ Owner’s Manual May 2013 190-01609-00_0A Printed in Taiwan
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. Go to www.garmin.com for current updates and supplemental information concerning the use of this product. Garmin® and the Garmin logo are trademarks of Garmin Ltd.
Table of Contents Introduction.................................................................... 1 Device Configuration .................................................................. 1 Profiles............................................................................ 1 Selecting a Profile ...................................................................... 1 Renaming a Profile .................................................................... 1 Creating Custom Profiles .........................
Introduction WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. Device Configuration NOTE: Certain functions are available only if the appropriate sensors are connected to the device. The GMI 20 allows you to view data provided by sensors connected to the device on a NMEA 2000® or NMEA® 0183 network. Custom (1,2,3): Empty profiles that allow you to build a new custom profile.
Configuring Graph Data Fields Some instrument pages display graph data. You can configure the data that displays on the graphs. > Configure Data 1 From the instrument page, select Fields. 2 Select an option: • To view the data as a number instead of a graph, select Show Number. • To change the type of data shown on the graph, select Graph Data. • To determine how long the graph data displays, select Graph Duration. • To configure the scale of values that display on the graph, select Graph Scale.
Configuring the Position Format NOTE: Do not change the position format or the map datum unless you are using a map or chart that specifies a different position format. Position Format sets the position format in which a given location reading appears. Map Datum sets the coordinate system on which the map is structured. > Setup > System > Position. 1 Select 2 Select an option: • To change the position format in which a reading appears, select Position Format.
Index A alarms anchor drag 3 deep water 3 fuel 3 shallow water 3 total fuel onboard 3 unit voltage 3 automatic scrolling 1 B beeper 2 D device, registration 3 display settings 3 F fuel alarm 3 G gauges, limits 2 H heading, heading type 2 I instruments 2 adding pages 2 configuration 1, 2 page order 2 removing pages 2 M marine, alarms setup 3 N NMEA 2000 3 P position format 3 product registration 3 profiles 1 custom 1 locking 1 renaming 1 restoring 1 selecting 1 unlocking 1 R registering the device
www.garmin.com/support 913-397-8200 1-800-800-1020 0808 238 0000 +44 870 850 1242 1-866-429-9296 +43 (0) 820 220 230 +32 2 672 52 54 +45 4810 5050 +358 9 6937 9758 + 331 55 69 33 99 +49 (0)180 6 427646 + 39 02 36 699699 0800 - 023 3937 035 - 539 3727 + 47 815 69 555 00800 4412 454 +44 2380 662 915 + 35 1214 447 460 + 34 93 275 44 97 + 46 7744 52020 Garmin International, Inc. 1200 East 151st Street Olathe, Kansas 66062, USA Garmin (Europe) Ltd.
