Installation Instructions

• Secure the included mounting template to the surface at

the chosen mounting location, along the bow-stern axis as

indicated on the template.

Determine which of the two mounting-hole patterns indicated

on the template are appropriate for the mounting surface and

drill the four mounting holes using a 15 mm (19/32 in.) drill

bit.

Remove the hatch on the front of the pedestal by loosening

the screw and lifting it off of the hinges.

Apply the included Petrolatum Primer to one half of the

threads of the four threaded rods.

Insert the ends of the threaded rods coated in Petrolatum

Primer into the pedestal, matching the hole pattern chosen in

step 2.

Tighten the threaded rods

using a 5 mm hex wrench

To avoid damaging the pedestal, you should stop tightening

the threaded rods when they no longer turn easily.

Install the isolators

over the threaded rods, and push them

securely onto the four raised locations on the bottom of the

pedestal

Mounting the Radar

Before you can mount the radar, you must first select a

mounting location, and prepare the mounting surface and the

radar (Preparing the Surface and the Radar for Mounting).

Take note of which end of the pedestal you plan to mount

facing the bow along the bow-stern axis.

If the hatch side is facing the bow, you must adjust the front-

of-boat offset on the chartplotter to receive an accurate radar

reading (Front-of-Boat Offset).

Position the included strap over the antenna, as close to the

pedestal base as possible

Hoist the radar into position, and carefully lower it onto the

mounting surface, feeding the threaded rods through the

holes.

From under the mounting surface, place the shoulder

washers

on the threaded rods and feed them into the

mounting surface so they fit securely.

Place the flat washers

, lock washers

, and hex nuts

on the threaded rods.

Torque the hex nuts to 1.5 kgf-m (130 lbf-in. [11 lbf-ft.]) to

securely fasten the radar to the surface without damaging the

radar or the mounting hardware.