Manual

C-3
C.2 ELECTRICAL WIRING
The GPS 95 power/data cable allows you to connect the unit to vehicle power
systems, other electronics, and a remote alarm/beeper. The power/data
cable has a 7-pin intermediate connector to facilitate quick disconnection of
all electrical connections and easy removal of the entire yoke mount from the
aircraft. The GPS 95 is supplied with two wire harnesses: one with a cigarette
lighter plug for temporary use and the other for permanent wiring. The figures
below illustrate the two wiring options.
OR
To connect to vehicle power systems...
· Connect the RED harness lead (with fuse) to the positive (+) side of a
5-40 volt DC power source.
· Connect the BLACK harness lead to the negative (-) side of the 5-40
volt DC power source.
The GPS 95 will drive a remote alarm or relay that requires no more than 100
milliamps of current. (WARNING: Devices which draw current in excess of
100 milliamperes may damage your unit and will void your warranty. Consult
the instructions included with the remote alarm or relay for current drain
information.)