Owner's Manual

GPSMAP 400/500 Series Owner’s Manual 59
Appendix
No Waypoints/Routes/Tracks/User Waypoints Found—attempted
to transfer user data from an SD card that does not contain the
specied type of data. Make sure there is data to transfer on the SD
card.
Off Course Alarm
—you are off course the distance set in the “Off
Course” alarm.
Route Already Exists
—you entered a route name that already exists
in memory. Modify the route name or delete the previous route
name.
Route Full
—you attempted to add more than 250 points to a route.
Reduce the number of points or create a second route.
Route Truncated—an uploaded route from another device has more
than 250 waypoints and was truncated to t.
Route Waypoint Memory Full
—no additional route waypoints can
be saved.
Shallow Water Alarm
—the Shallow Water Alarm depth has been
reached.
Sonar Service Incompatible
—the external sonar device you are
connected to needs a software update.
Sonar Timeout—there is an internal problem with the unit. Contact
your dealer or Garmin Product Support to have the unit serviced.
Sonar Service Lost—the external sonar device you were connected
to has either been disconnected or the unit has lost communication
with the sonar device for some other reason.
Track Already Exists [Track Name]
—you entered a saved track
name that already exists in memory. Modify the track name or delete
the existing track.
Track Log Full
—the track log is full and track recording has been
turned off. To record more track points, you need to clear the track
log and turn track recording on. This only appears when the track
recording setting is set to “Stop When Full.”
Track Memory is Full, Can’t Create Track
—the track log
memory is full. No additional track log data can be stored without
deleting old data to create memory space.
Track Truncated—a complete uploaded track does not t into
memory. The oldest track log points were deleted to make space for
the most recent data.
Transducer Disconnected, Sonar Turned Off
—there is not
a transducer attached, there is a bad cable or transducer, or the
transducer cable was disconnected. If the transducer cable is
removed while the unit is on, reconnect and cycle power.
Transfer Complete—the unit has nished uploading or
downloading information to the connected device.