GTM 11 ™ fm tmc traffic receiver owner’s manual GTM 11 shown with the whip antenna
© Copyright 2005–2006 Garmin Ltd. or its subsidiaries Garmin International, Inc. 1200 East 151st Street Olathe, Kansas 66062, U.S.A. Tel. 913/397.8200 or 800/800.1020 Fax 913/397.8282 Garmin (Europe) Ltd. Garmin Corporation No. 68, Jangshu 2nd Road Unit 5, The Quadrangle Abbey Park Industrial Estate Shijr, Taipei County, Taiwan Romsey, SO51 9DL, U.K. Tel. 886/2.2642.9199 Fax 886/2.2642.9099 Tel. 44/0870.8501241 Fax 44/0870.8501251 All rights reserved.
FM TMC TRAFFIC Using the Garmin® GTM™ 11 FM TMC Traffic Receiver, your Garmin GPS device receives and uses Traffic Message Channel (TMC) information that is broadcast over the FM radio data system. Service Information The GTM 11 includes an FM TMC traffic subscription to a pay service; however, the subscription varies, depending on your location. You can add other FM TMC subscriptions at any time. Check the Garmin Web site at http://www.garmin.com/fmtraffic for other available services.
CONNECTING THE GTM 11 CONNECTING THE GTM 11 What’s Included • • • • • Step 2: Connect the GTM 11 to your GPS device GTM 11 with LED and mini-USB plug Whip antenna (stiff antenna) Wire antenna (flexible wire antenna) Hook-and-loop fasteners Double-sided tape Connect the mini-USB plug on the GTM 11 cable into the mini-USB connector on your Garmin GPS device. Step 1: Snap the antenna on the GTM 11 You can use either the whip or wire antenna for your GTM 11.
TESTING AND MOUNTING THE GTM 11 TESTING THE GTM 11 MOUNTING THE GTM 11 Use the following testing and troubleshooting techniques: Observe the LED on the GTM 11: Service reception is indicated by the green solid light, which can take up to five minutes to appear for initial data acquisition. Yellow dot-dash flashes: determining which country you are currently in. Yellow solid light: searching table for active entry or scanning for new TMC FM stations Red solid light: momentary sync loss.
TESTING AND MOUNTING THE GTM 11 To mount the GTM 11 with the hook-and-loop fastener: 1. Clean and dry a section of the A-pillar or other suitable mounting surface. 2. Remove the backing from the back of the loop material. 3. Firmly press the loop material to the mounting surface. 4. Remove the backing from the back of the hook material. 5. Firmly press the hook material to the back of the GTM 11. Attach the hook material here.
USING TRAFFIC DATA WITH YOUR GARMIN GPS DEVICE USING TRAFFIC DATA WITH The GTM 11 works with your Garmin GPS device to show traffic flow and incident information and enable routing around the traffic incident. Although each GPS device operates differently, they all provide the same basic traffic information. NOTE: The GTM 11 and GPS device must be in data range of an FM station transmitting TMC data. NOTE: Garmin is not responsible for the accuracy of the traffic information.
Traffic Service End User Subscriber Agreement The Traffic Service Provider holds the rights to the traffic incident data and RDS/TMC network through which it is delivered. You may not modify, copy, scan, or use any other method to reproduce, duplicate, republish, transmit, or distribute in any way any portion of traffic incident data. You agree to indemnify, defend, and hold harmless the Traffic Service Provider (and its affiliates) and Garmin Ltd.